TSMC chip fabs may be vulnerable to chemical and gas contamination
Disclaimer
Contains politically sensitive info
Quick Note
Main
TSMC chip fabs contain cleanrooms spanning tens of thousands of square metres
TSMC has previously reported chemical contamination that cost them $500 million. They have also reported gas contamination in the past.
If you wish to make TSMC chip fabs inoperational, the most effective method might (???) be drone swarm attack, where the drone swarms infiltrate the cleanroom then attempt contamination via chemical or gas.
2026-10-25
Update
Which chemical or gas to use as an important question I don't yet have a good answer to.
Obviously explosives (like RDX) are an option, but that will require a lot of explosives given there are atleast 100 lithograhy machines you need to simultaneously destroy. And smuggling explosive material is not easy.
Acid can corrode steel quickly, but is high in density hence not my first bet. For density reasons, using a gas makes the most sense here.
Flourine gas is corrosive to silicon even in low concentrations, hence high-pressure flourine gas might be an option? Flourine is in general corrosive to lots of compounds. Might be better than hydroflouric acid for density reasons. See also: Wikipedia on SiF4. Flourine itself is cheap, but lab facilities to handle it are sufficiently expensive that I am again unsure if this method is any easier than just using explosives.
I don't know enough about this topic to comment more at this moment.
Subscribe
Enter "Subscribe: " followed by Signal username, email address or whatsapp phone number. You will receive atmost one update per month. View previous updates here.
Alternatively, you can use RSS, or a third-party service like blogtrottr.
Comment
Enter "Comment: " followed by comment. Alternatively, contact me